Difference between revisions of "RP2040"
From ScienceZero
Line 20: | Line 20: | ||
* DMA interface, sustained throughput up to 1 word per clock from system DMA | * DMA interface, sustained throughput up to 1 word per clock from system DMA | ||
* IRQ flag set/clear/status | * IRQ flag set/clear/status | ||
+ | |||
== Instruction set == | == Instruction set == |
Revision as of 19:07, 10 August 2022
Memory
- A 16kB read-only memory (ROM) is at address 0x00000000
- Off-chip execute-in-place (XIP) flash interface (2MB on Raspberry Pi Pico) at address 0x10000000
- Four 16k x 32-bit banks of SRAM (64kB each)
- Word striped at 0x20000000
- Non striped at 0x21000000, 0x21010000, 0x21020000 and 0x21030000
- Two 1k x 32-bit banks of SRAM (4kB each) at 0x20040000 and 0x20041000
- If flash XIP caching is disabled, the cache becomes available as 16kB SRAM starting at 0x15000000
- If the USB is not used, the USB data DPRAM can be used as a 4kB memory starting at 0x50100000
Programmable input/output block (PIO)
There are two PIO blocks with four state machines each, that can independently execute sequential programs to manipulate GPIOs and transfer data. Unlike a general purpose processor, PIO state machines are highly specialised for IO, with a focus on determinism, precise timing, and close integration with fixed-function hardware. Each state machine is equipped with:
- Two 32-bit shift registers – either direction, any shift count
- Two 32-bit scratch registers
- 4×32-bit bus FIFO in each direction (TX/RX), reconfigurable as 8×32 in a single direction
- Fractional clock divider (16 integer, 8 fractional bits)
- Flexible GPIO mapping
- DMA interface, sustained throughput up to 1 word per clock from system DMA
- IRQ flag set/clear/status
Instruction set
All PIO instructions are 16 bits long and execute in a single cycle with no pipeline.
Bit: 15-13 | 12 11 10 9 8 | 7 6 5 | 4 3 2 1 0 JMP 0 0 0 | Delay/side-set | Condition | Address WAIT 0 0 1 | Delay/side-set | Pol|Source | Index IN 0 1 0 | Delay/side-set | Source | Bit-count OUT 0 1 1 | Delay/side-set | Destination | Bit-count PUSH 1 0 0 | Delay/side-set | 0| IfF |Blk | 0 0 0 0 0 PULL 1 0 0 | Delay/side-set | 1| IfE |Blk | 0 0 0 0 0 MOV 1 0 1 | Delay/side-set | Destination | Op | Source IRQ 1 1 0 | Delay/side-set | 0|Clr|Wait | Index SET 1 1 1 | Delay/side-set | Destination | Data